A
aditya
Guest
Hi,
I am using NCSU CADENCE design kit for my design . I put a layout of
1200 Ohm resistor but when I try to extract the extracted netlist
doesnt show the resistor . I used all the methods (putting res_id etc)
listed on the ncsu website but cant extract the resistor . In the
extraction dialog box there is no switch specified for extraction of
drawn resistor or capacitor .
How do I extract a resistor??????
with regards
aditya
I am using NCSU CADENCE design kit for my design . I put a layout of
1200 Ohm resistor but when I try to extract the extracted netlist
doesnt show the resistor . I used all the methods (putting res_id etc)
listed on the ncsu website but cant extract the resistor . In the
extraction dialog box there is no switch specified for extraction of
drawn resistor or capacitor .
How do I extract a resistor??????
with regards
aditya