Help required for disassembly and trouble shooting SONY WEGA

[tifr]

My Sony Trinitron CRT Model KV AZ-212 MB3 ( SONY 21" CRT WEGA)was for
few months been showing a 'pincushion' ") (" type of screen which
tended to ignore.
Unitil suddenly it got worse and fumes started to emerge out of it.
I have now opened it. But, I was finding it difficult to access the PCB
The moment the back cover is removed the front started to be quit
unstable. The CRT is so heavy that I had to lay the TV with the scree
facing down. After this, I am stuck as I do not know how to access th
PCB. Now, only the back of the PCB is seen with the CRT facing down
Also, I have noticed that a diode is burned.

My query is as follows:
1) How to disassemble the TV properly? Any Instructions step by step?
2) how to access and remove the PCB?
3) What are the likely problems?
4) And the likely solutions?
Thanks


--
tifr

 

[Mike Tomlinson]

En el artículo <tifr.a1caf88@diybanter.com>, tifr
<tifr.a1caf88@diybanter.com> escribió:

1) How to disassemble the TV properly? Any Instructions step by step?
2) how to access and remove the PCB?
3) What are the likely problems?
4) And the likely solutions?

No offence, but if you need to ask that sort of question you're not
experienced enough to attempt repair of a TV set, particularly as they
can carry dangerous voltages for a surprisingly long time after power
has been unplugged.

Put the cover back on and take it to someone who is qualified to fix it.
It's not a serious fault and an experienced technician will be able to
sort it out in half an hour or so.

--
(\_/)
(='.'=)
(")_(")

 

[tifr]

Thanks Mike for the advice. You guessed it right. Not a TV servic
person. But there is always a first time.

I know the fault may not be a major one and I have the feeling to b
able to tackle it successfully. But I am stuck on the first step only.

The reason for my taking this up on my own is that there is nobody her
who can do this work in this part of the country. Even if there is i
could be a expensive now that people rarely service TVs.

I am relying a lot on this site for some moral and technical support.

Hope you will understand. Thanks again I will be careful


--
tifr

 

[Franc Zabkar]

On Tue, 12 Jun 2012 07:22:31 +0000, tifr <tifr.a1caf88@diybanter.com>
put finger to keyboard and composed:

My Sony Trinitron CRT Model KV AZ-212 MB3 ( SONY 21" CRT WEGA)was for a
few months been showing a 'pincushion' ") (" type of screen which I
tended to ignore.

Do the following service manuals help at all?

http://service.eclubthai.com/new/Tv/Sony/KV-AZ21M60.pdf
http://www.eserviceinfo.com/download.php?fileid=40515

- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.

 

[tifr]

Thanks

The first link leads to a page which says: 'the source is not trusted'
so I did not proceed further

The 2nd link is a circuit diagram of the KV BT21M20. Hope that it is th
one that I am looking for.!!! or something similar to what i need jus
now.!

Any input on what could be the likely problem?
-


--
tifr

 

[Franc Zabkar]

On Tue, 19 Jun 2012 11:56:39 +0000, tifr <tifr.a263e68@diybanter.com>
put finger to keyboard and composed:

The 2nd link is a circuit diagram of the KV BT21M20. Hope that it is the
one that I am looking for.!!! or something similar to what i need just
now.!!

If your chassis number matches that of the service manual (BX1S), then
the circuit diagram should be similar.

Any input on what could be the likely problem??

I'm not familiar with your model, but I would start by working
backwards from the fumes. As for the pincushion problem, troubleshoot
the deflection board.

- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.