GE TV 27GT610 Audio Problem

[Roger Grady]

My GE 27GT610 has lost the right channel audio. Anybody know if
there's a common/simple problem that might cause this? I don't have a
service manual and am reluctant to spend $20 or $30 for one for a
12yr. old set.


Roger Grady k9opo@comteck.qlfit.com
To reply by email, remove "qlfit." from address

 

[Sofie]

Roger Grady:
Check the settings for the audio..... set it for "stereo" or "mono" .......
make certain it is not in the "SAP" mode.
--
Best Regards,
Daniel Sofie
Electronics Supply & Repair
------------------



"Roger Grady" <k9opo@comteck.qlfit.com> wrote in message
news:3fc1862b.22645106@news.comteck.com...

My GE 27GT610 has lost the right channel audio. Anybody know if
there's a common/simple problem that might cause this? I don't have a
service manual and am reluctant to spend $20 or $30 for one for a
12yr. old set.


Roger Grady k9opo@comteck.qlfit.com
To reply by email, remove "qlfit." from address

 

[Roger Grady]

"Sofie" <sofie@olypen.com> wrote:

Roger Grady:
Check the settings for the audio..... set it for "stereo" or "mono" .......
make certain it is not in the "SAP" mode.

Thanks but that's not it - set doesn't have SAP, and R channel is
dead in either Stereo or Mono. And I just discovered when I turned it
on to check your suggestion that it's an intermittent. The R channel
was working at first but then went off after several minutes. This is
a CT167R chassis - is that known to have solder joint problems?


Roger Grady k9opo@comteck.qlfit.com
To reply by email, remove "qlfit." from address