Guest
Someone was asking about eti 4000 speakers i have lost the article but have found the eti article on four way transmission line speakers. I have also found how to build a three way active crossover. The only point of transmission lines is to extend the base frequencies. The best you can achieve is to reach the manufactures lowest claims eg 30 hz. A lot of calculations will be needed to make it work. The eti article is not correct for transmission lines. Anyway if you used the same drivers and say used bass reflex you would come close to the dame claimed figures. One could use a subwoofer to get clean bottom end. I have been looking at passive radiators they will do a similar job to lines. Then i looked at 12" twin cone speakers. To my knowledge a combination of dual coan plus passive radiators don't exist. In theory built as a two way speaker should be truely magnificent.tri amped should be the way to go. I can supply a set of plans for a 2 or 3 way active crossover. Also i have plans for a 100 watt rms mosfet amp. Main drivers would not be available for amp look on net for plans. Bottom end would also require an 18" sub to truely lineal.