Focus Adjustment on a ViewSonic P810 21" monitor

[Peter]

I am not sure if anyone has read up on my previous messages or not, but I
believe I have since fixed my monitor problem.

I pretty much just re-flowed all the solder around the flyback and anything
else that I came across and now it seems to be working fine except it's a
little fuzzy.

There is a little hole in the back of the monitor that I questions whether
or not it's the access hole for the focus. I would like to not have to take
the monitor apart again if I could avoid it and if this is the access hole,
it would make my life so much easier.

Does anyone haev any input?

Thanks

 

[Jerry G.]

Open the monitor and look for the focus pot. In most monitors it is on the
flyback assy., and is built in to part of the HV multiplier.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
=========================================


"Peter" <bpeter97@aol.com> wrote in message
news:094Hb.671300$Fm2.582333@attbi_s04...
I am not sure if anyone has read up on my previous messages or not, but I
believe I have since fixed my monitor problem.

I pretty much just re-flowed all the solder around the flyback and anything
else that I came across and now it seems to be working fine except it's a
little fuzzy.

There is a little hole in the back of the monitor that I questions whether
or not it's the access hole for the focus. I would like to not have to take
the monitor apart again if I could avoid it and if this is the access hole,
it would make my life so much easier.

Does anyone haev any input?

Thanks