N
Nutty Professor
Guest
Hi all
I have a Bosch PMS100 scopemeter, similar to the Fluke98 ( in fact the same
but with Bosch software)
The meter is working at present off normal C-cell batteries.
It used to work with the supplied Ni-Cads but has stopped charging the
Ni-Cads via the charger.
Replaced the battery pack still not charging.
The batteries are charged via the scopemeter internally , a charger attaches
to the side of the scopemeter.
Does anyone have experience of this problem?
Also can anyone help me by emailing me a schematic.
The problem I would assume lies in possibly a regulator or another component
going down in the 9V sharging circuit.
Any help or direction is appreciated, thank you in advance.
Regards
Nutty Professor
I have a Bosch PMS100 scopemeter, similar to the Fluke98 ( in fact the same
but with Bosch software)
The meter is working at present off normal C-cell batteries.
It used to work with the supplied Ni-Cads but has stopped charging the
Ni-Cads via the charger.
Replaced the battery pack still not charging.
The batteries are charged via the scopemeter internally , a charger attaches
to the side of the scopemeter.
Does anyone have experience of this problem?
Also can anyone help me by emailing me a schematic.
The problem I would assume lies in possibly a regulator or another component
going down in the 9V sharging circuit.
Any help or direction is appreciated, thank you in advance.
Regards
Nutty Professor