Flat panel set blooming

D

David Lesher

Guest
I have a orphaned Olevia TV that has just developed an ugly new symptom.

There are blooms/blotches of ~red appearing on darker scenes. It's most
obvious on older B+E rerun shows such as Route 66 & I Spy. But I
have seen them on low-def color shows.

I don't see them on network 720P feeds. At least now...

Any suggestions?


--
A host is a host from coast to coast.................wb8foz@nrk.com
& no one will talk to a host that's close..........................
Unless the host (that isn't close).........................pob 1433
is busy, hung or dead....................................20915-1433
 
That's not called blooming, but no big deal.

If the splotches are stationary and onbly in certain modes it is most likely decoding errors, and that is usually on the main board. If it was in all modes I would say it might be the panel or Tcon, but it isn't.

Slight possibility of it being bad caps, but very slight.

Try looking for settings that are channel or mode specific in the menu(s). Of you find them you might find the broghtness turned too low for one mode or sometning. Sometimes LCD panels "overtwist" which can do things like this. That is ALOT more noticable on an edgre lit display like a laptop PC. Regular backlit monitors are alot better about that now, unlike years before when they didn't have the viewing angle.

If it is overtwist, likely you will see a difference when you change your angle. I it looks significantly different from the left, right, above or below, just adjusting the brightness (pedestal) might fix you up. I do not mean in different places, I mean more or less pronounced.

Even if there is a minor fault, adjustments might make it watchable. Especially if it has a gamma control. I doubt it does, but if it does you can play with that.
 
On Thursday, November 6, 2014 8:24:54 PM UTC-5, David Lesher wrote:
I have a orphaned Olevia TV that has just developed an ugly new symptom.

There are blooms/blotches of ~red appearing on darker scenes. It's most
obvious on older B+E rerun shows such as Route 66 & I Spy. But I
have seen them on low-def color shows.

I don't see them on network 720P feeds. At least now...

Any suggestions?

It *sounds* a bit like LCD delamination, but if it was, it wouldn't be specific to resolution settings. Generally, if the area in question has no clear cut boundaries or line of demarcation and looks more like a stain, it's the display. If you post a pic on line and link it, we can get a better idea.
 

Welcome to EDABoard.com

Sponsor

Back
Top