Fault TEAC EU-80ST - Intermittent aspect ratio change - Help

M

Mike

Guest
Anyone have any ideas on a display fault where the image appears to change
aspect ratios from normal to widescreen? It occurs irregularly but
frequently, sometimes 3 times in a minute. I have checked (I think) the
install settings and the display settings. It still occurs when set on any
off 16:9, 4:3, or Auto selection. It occurs on FTA and Cable.
Kind Regards
Mike
 
"Mike" <mike@(nospam).com.au> wrote in message
news:409c9afc$0$27657$afc38c87@news.optusnet.com.au...
Anyone have any ideas on a display fault where the image appears to change
aspect ratios from normal to widescreen? It occurs irregularly but
frequently, sometimes 3 times in a minute. I have checked (I think) the
install settings and the display settings. It still occurs when set on any
off 16:9, 4:3, or Auto selection. It occurs on FTA and Cable.
Kind Regards
Mike
Click to expand...
Further to the above it does not occur on DVD playback on AV-1 but only on
tuned channels. It has also now progressed to not showing the full image at
all on FTA channels. All station logos are half off screen and left side of
image shows extreme curvature.
Regards
Mike
 
Check electrolitics in IF section.

Rudolf

"Mike" <mike@(nospam).com.au> wrote in message
news:409c9afc$0$27657$afc38c87@news.optusnet.com.au...
Anyone have any ideas on a display fault where the image appears to change
aspect ratios from normal to widescreen? It occurs irregularly but
frequently, sometimes 3 times in a minute. I have checked (I think) the
install settings and the display settings. It still occurs when set on any
off 16:9, 4:3, or Auto selection. It occurs on FTA and Cable.
Kind Regards
Mike
Click to expand...
 
"Rudolf Ladyzhenskii" <rudolfl@optusnet.com.au> wrote in message
news:409f6827$0$25657$afc38c87@news.optusnet.com.au...
Check electrolitics in IF section.

Rudolf

"Mike" <mike@(nospam).com.au> wrote in message
news:409c9afc$0$27657$afc38c87@news.optusnet.com.au...
Anyone have any ideas on a display fault where the image appears to
change
aspect ratios from normal to widescreen? It occurs irregularly but
frequently, sometimes 3 times in a minute. I have checked (I think) the
install settings and the display settings. It still occurs when set on
any
off 16:9, 4:3, or Auto selection. It occurs on FTA and Cable.
Kind Regards
Mike

Thank you Rudolf. Will advise.
Click to expand...
Regards
Mike
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top