Error while netlistin when adding pins in VerilogA

[Fritz Lange]

Hello,

I have the following problem, using VerilogA.

When I add a pin in a VerilogA module, I update my symbol cellview using
Desing->Create Cellview-> from Cellview.
After that I can use modify or recreate.

In both cases I get the following error while netlisting under spectre.

ERROR: Netlister : terminal 'vout2' of instance 'I0', in cell
'JITTERGEN_SIM_pA1', view 'schematic' : cannot be found in the switched
master of the instance.


Does anybody have a solution?


Thanks for any suggestion

Norman

 

[westlaker]

Fritz Lange wrote:

Hello,

I have the following problem, using VerilogA.

When I add a pin in a VerilogA module, I update my symbol cellview using
Desing->Create Cellview-> from Cellview.
After that I can use modify or recreate.

In both cases I get the following error while netlisting under spectre.

ERROR: Netlister : terminal 'vout2' of instance 'I0', in cell
'JITTERGEN_SIM_pA1', view 'schematic' : cannot be found in the switched
Why the view is schematic? Do you have a schematic view for this cell? If

you set the view to be use (I assume you want to use VerilogA view) right,
the netlister should not go looking for a schematic view. The way you set
this depends on your software usage. If you are using AMS designer, it's
through the hierachy editor.

Hope this helps.

master of the instance.


Does anybody have a solution?


Thanks for any suggestion

Norman