error in using ocnprint

[jimmy]

Hi,

I always use Ocnprint to save data in cadence. Sometime I encountered
such a problem. Let me describe it using an example.

If I want to run a transident analysis for 100us. During the long
simulation, I like to use direct plot to view the on-going results.
The problem is: if I viewed the data at 20us. Then if I want to use
direct plot to view the data again later, I can not see data after
20us. If I use Ocnprint to save data, I can only save valid data up to
20us. However, i can still use result browser to view updated data.

I have no idea what is wrong?

Thank you for your help,

jimmy li

 

[Erik Wanta]

Jimmy:
I have not tried it but I see a few functions that might help.

simDrain()
artFlush()
---
Erik

lizh@ece.orst.edu (jimmy) wrote in message news:<c8960588.0411241320.7dc12864@posting.google.com>...

Hi,

I always use Ocnprint to save data in cadence. Sometime I encountered
such a problem. Let me describe it using an example.

If I want to run a transident analysis for 100us. During the long
simulation, I like to use direct plot to view the on-going results.
The problem is: if I viewed the data at 20us. Then if I want to use
direct plot to view the data again later, I can not see data after
20us. If I use Ocnprint to save data, I can only save valid data up to
20us. However, i can still use result browser to view updated data.

I have no idea what is wrong?

Thank you for your help,

jimmy li