erasing a MAX device

[Rene Tschaggelar]

A feature forgotten by the developpers of the MaxPlus2
software is the ability to just erase a (MAX) device.
Having some troubles with some other hardware which
should have defined output pins going to defined input pins
on a MAX3128 leads to this device not being initialized.
This makes the MAX3128 have open inputs drawing too much power.

There wasn't any problem before the MAX3128 was programmed,
and I therefore wish to erase the MAX3128. Just erase.

Rene
--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
& commercial newsgroups - http://www.talkto.net

 

[Rene Tschaggelar]

Rene Tschaggelar wrote:

A feature forgotten by the developpers of the MaxPlus2
software is the ability to just erase a (MAX) device.
Having some troubles with some other hardware which
should have defined output pins going to defined input pins
on a MAX3128 leads to this device not being initialized.
This makes the MAX3128 have open inputs drawing too much power.

There wasn't any problem before the MAX3128 was programmed,
and I therefore wish to erase the MAX3128. Just erase.

BTW. I found the appnote telling about using the JAM player.
jam -dDO_ERASE ...

But why not just have a button in the usual software ?

Rene