DSA602 defaults

[sebastian]

hello

does anybody know how to set this scope to defaults.I had minimized the
display brightness and now i see nothing and i don't know how to change the
screen to be bright.please help anybody

seba

 

[carneyke]

On Jun 1, 12:30 pm, "sebastian" <gen...@o2.pl> wrote:

hello

does anybody know how to set this scope to defaults.I had minimized the
display brightness and now i see nothing and i don't know how to change the
screen to be bright.please help anybody

seba
It looks like there are 3 batteries, remove / test/ replace as needed.

Below is how aworking scope is initalised:
Press Utility
Initialise settings in the Utility menu
Initalise settings in the Verify pop-up menu

 

[Andrew]

I cribbed this from the Tek website.

Q.

My 11402 has locked up. I have tried powering it off, then on again with
no success. How can I resolve problem?
A.


When the instrument's power is cycled, the instrument tries to return to
the same conditions as when it was powered down. Unfortunately, that can
include conditions like you are experiencing. Returning the instrument
to factory default conditions will usually correct these problems. NOTE:
All settings and waveforms will be erased when you reset the instrument
to its default settings. This procedure to do this is as follows:

Turn off the instrument. Hold down the Waveform and Trigger menu
buttons, while turning the instrument on. When the menu lights start
flashing, the buttons can be released. The instrument should display a
message indicating that factory defaults are being restored and
everything except the number of power-ups, the serial number and the
time/date has been erased.

regards Andrew