P
Poojan Wagh
Guest
Hi, cadence experts.
I have a mostly basic problem that has been bugging me. Normally, when
I open up a schematic, my device parameters (width, length, m-factors,
etc.) show up next to the device. If I run spectre (for example) and
choose results->annotate->device parameters, I can get currents, etc.
to show up. However, after running these sims and going back to
results->annotate->design defaults, all my parameters disappear.
Is there any way to get back, to the original annotations (other than
quitting & restarting icfb)?
I have a mostly basic problem that has been bugging me. Normally, when
I open up a schematic, my device parameters (width, length, m-factors,
etc.) show up next to the device. If I run spectre (for example) and
choose results->annotate->device parameters, I can get currents, etc.
to show up. However, after running these sims and going back to
results->annotate->design defaults, all my parameters disappear.
Is there any way to get back, to the original annotations (other than
quitting & restarting icfb)?