R
RoDnSuE
Guest
Hi,
I have a slightly sick Cushman CE50-TG-1 service monitor and was
wondering if anyone has taken any voltage readings from a working unit
they would be willing to share.
I need to check the voltages at test points 3 & 4 on the 29000 board
with the frequency set between 9.9999mhz and 100khz. That should give
me the normal range for both the A & B VCO's control voltage's.
(referenced to chassis ground) Any other voltages would be helpful so I
can note them for future reference.
Sure would have been nice if Cushman would have provided some basic
voltage readings on the schematics.
Any help would be appreciated,
Thanks,
RoD
I have a slightly sick Cushman CE50-TG-1 service monitor and was
wondering if anyone has taken any voltage readings from a working unit
they would be willing to share.
I need to check the voltages at test points 3 & 4 on the 29000 board
with the frequency set between 9.9999mhz and 100khz. That should give
me the normal range for both the A & B VCO's control voltage's.
(referenced to chassis ground) Any other voltages would be helpful so I
can note them for future reference.
Sure would have been nice if Cushman would have provided some basic
voltage readings on the schematics.
Any help would be appreciated,
Thanks,
RoD