Corner Models in PSPICE?

[Eric]

Howdy Gurus,

I am using the student version (9.2) of Orcad Pspice. For some MOSIS runs,
MOS corner models are published, but I can't figure out how to use them in
Capture/Pspice. I have successfully implemented the MOSIS models and can
parametrically sweep (width and length, for example). The following entry
for the FAQ served only to confuse me. Does someone have an example they
could post?

Thanks a mil!
Eric

ref:

from: http://www.orcadpcb.com/kb_articles/020577.asp?bc=F
----------------------------------------------------------------------------
------------------------

3. Parameter Definitions
There are five sets of parameter definitions (.param statements), for the
process corners:
1.. TT : typical model
2.. SS : Slow NMOS Slow PMOS model
3.. FF : Fast NMOS Fast PMOS model
4.. SF : Slow NMOS Fast PMOS model
5.. FS : Fast NMOS Slow PMOS model
These parameter definitions should be placed in include files, one for each
process corner, which can be configured for use with PSpice to simulate the
desired process corner.

Document number: PSP02577
Applies to: PSpice ver. All
Created on: 27-OCT-1999
Last modified: 1-NOV-1999