Connecting bus signals to gnd

[L. Coleman]

I'm getting errors in Virtuoso schematic composer when I try to connect
signals on a bus to gnd. The errors are that the signals are shorted
to gnd and that they're shorted together. I was able to get rid of the
errors by putting a patch component (from basic library) between gnd
and each bus signal. However the patch causes an error when running
the "generate from source" command in the layout editor. I also tried
a 0 ohm resistor, which also got rid of the error in the schematic but
caused an error in layout. Any suggestions?

 

[L. Coleman]

Thanks for the advice. I tried it out & it got rid of my errors.