32' Sony tv KV-32V16,chassis:SCC-F85R-A

S

Sidney

Guest
32" Sony PIP stereo tv model:KV-32V16,chassis:SCC-F85R-A &
AA-1,year:Nov 1995.After about 3 hours of running or so the tv shuts
off and when power button is pressed the tv turns on for 1 second then
shuts off again,when power button is pressed again it turns of for a
few minutes then starts the process all over until the tv is allowed
to cool down for a few hours.
The standby LED light is not blinking so I cannot pull the codes,I
found extensive cracked solder joints throughout the unit and I
resoldered,the solder in the horizontal section was fine believe it or
not but I resoldered it as well.
This unit uses Flyback # 8-451-315-41 or 1-439-498-71

Here are other models which share the same chassis:

Chassis: AA-1

Model :
KV-27S10 / 15
KV-27TS29 / 29 / 32 / 36
KV-27TW77 / 78
KV-27V10 / 15 / 55
KV-27XBR37 / 45
KV-32S10 / 12 / 15 / 16
KV-32TS36 / 46
KV-32TW67 / 68 / 77 / 78
KV-32V15 / 16
KV-32XBR37 / 45 / 85

Taken from:

http://www.iwaynet.net/~nesda/SonyCross.html

Thanks in advance for help.
 
If the set shuts after it gets warmed up and will restart when cold, I
would be looking for thermo sensitive components. The electrolytic caps
in the scans and power supply in many sets are known for this type of
fault.

You can use a heat gun, and freeze-mist cooling spray to help
troubleshoot for thermo sensitive components. Each time you cool the
suspect parts, you will have to recycle the power, to see if it will
start again.

One method I use is to heat the suspect caps with a heat gun, and then
test them with an ESR meter while they are still hot. This is a bit
easier, depending on the accessibility of the underside of the board in
this approach, and the situation.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
==============================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
==============================================
"Sidney" <sidneybek@yahoo.com> wrote in message
news:fecdbb87.0307250544.71d4ea89@posting.google.com...
32" Sony PIP stereo tv model:KV-32V16,chassis:SCC-F85R-A &
AA-1,year:Nov 1995.After about 3 hours of running or so the tv shuts
off and when power button is pressed the tv turns on for 1 second then
shuts off again,when power button is pressed again it turns of for a
few minutes then starts the process all over until the tv is allowed
to cool down for a few hours.
The standby LED light is not blinking so I cannot pull the codes,I
found extensive cracked solder joints throughout the unit and I
resoldered,the solder in the horizontal section was fine believe it or
not but I resoldered it as well.
This unit uses Flyback # 8-451-315-41 or 1-439-498-71

Here are other models which share the same chassis:

Chassis: AA-1

Model :
KV-27S10 / 15
KV-27TS29 / 29 / 32 / 36
KV-27TW77 / 78
KV-27V10 / 15 / 55
KV-27XBR37 / 45
KV-32S10 / 12 / 15 / 16
KV-32TS36 / 46
KV-32TW67 / 68 / 77 / 78
KV-32V15 / 16
KV-32XBR37 / 45 / 85

Taken from:

http://www.iwaynet.net/~nesda/SonyCross.html

Thanks in advance for help.
 
May want to chenk with Sony directly to see if there are any service
bulletins regarding this symptom.
"Jerry G." <jerryg@total.net> wrote in message
news:bfrkjj$nc9$1@news.eusc.inter.net...
If the set shuts after it gets warmed up and will restart when cold, I
would be looking for thermo sensitive components. The electrolytic caps
in the scans and power supply in many sets are known for this type of
fault.

You can use a heat gun, and freeze-mist cooling spray to help
troubleshoot for thermo sensitive components. Each time you cool the
suspect parts, you will have to recycle the power, to see if it will
start again.

One method I use is to heat the suspect caps with a heat gun, and then
test them with an ESR meter while they are still hot. This is a bit
easier, depending on the accessibility of the underside of the board in
this approach, and the situation.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
==============================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
==============================================
"Sidney" <sidneybek@yahoo.com> wrote in message
news:fecdbb87.0307250544.71d4ea89@posting.google.com...
32" Sony PIP stereo tv model:KV-32V16,chassis:SCC-F85R-A &
AA-1,year:Nov 1995.After about 3 hours of running or so the tv shuts
off and when power button is pressed the tv turns on for 1 second then
shuts off again,when power button is pressed again it turns of for a
few minutes then starts the process all over until the tv is allowed
to cool down for a few hours.
The standby LED light is not blinking so I cannot pull the codes,I
found extensive cracked solder joints throughout the unit and I
resoldered,the solder in the horizontal section was fine believe it or
not but I resoldered it as well.
This unit uses Flyback # 8-451-315-41 or 1-439-498-71

Here are other models which share the same chassis:

Chassis: AA-1

Model :
KV-27S10 / 15
KV-27TS29 / 29 / 32 / 36
KV-27TW77 / 78
KV-27V10 / 15 / 55
KV-27XBR37 / 45
KV-32S10 / 12 / 15 / 16
KV-32TS36 / 46
KV-32TW67 / 68 / 77 / 78
KV-32V15 / 16
KV-32XBR37 / 45 / 85

Taken from:

http://www.iwaynet.net/~nesda/SonyCross.html

Thanks in advance for help.
Click to expand...
 
Symptom is consistent with a shorted picture tube in that model. Usually
the green gun but not always.

Look for any sign of bright color image when it shuts down to confirm.

Two things will allow the set to come up about3 to 5 seconds before shutdown
(not xray protect which disables turn on attempt until unplugging tv).
1. Excessive beam current, shorted crt.
2. Loss of vertical return pulse to the system control, usually a vertical
output problem.

David

Jerry G. <jerryg@total.net> wrote in message
news:bfrkjj$nc9$1@news.eusc.inter.net...
If the set shuts after it gets warmed up and will restart when cold, I
would be looking for thermo sensitive components. The electrolytic caps
in the scans and power supply in many sets are known for this type of
fault.

You can use a heat gun, and freeze-mist cooling spray to help
troubleshoot for thermo sensitive components. Each time you cool the
suspect parts, you will have to recycle the power, to see if it will
start again.

One method I use is to heat the suspect caps with a heat gun, and then
test them with an ESR meter while they are still hot. This is a bit
easier, depending on the accessibility of the underside of the board in
this approach, and the situation.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
==============================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
==============================================
"Sidney" <sidneybek@yahoo.com> wrote in message
news:fecdbb87.0307250544.71d4ea89@posting.google.com...
32" Sony PIP stereo tv model:KV-32V16,chassis:SCC-F85R-A &
AA-1,year:Nov 1995.After about 3 hours of running or so the tv shuts
off and when power button is pressed the tv turns on for 1 second then
shuts off again,when power button is pressed again it turns of for a
few minutes then starts the process all over until the tv is allowed
to cool down for a few hours.
The standby LED light is not blinking so I cannot pull the codes,I
found extensive cracked solder joints throughout the unit and I
resoldered,the solder in the horizontal section was fine believe it or
not but I resoldered it as well.
This unit uses Flyback # 8-451-315-41 or 1-439-498-71

Here are other models which share the same chassis:

Chassis: AA-1

Model :
KV-27S10 / 15
KV-27TS29 / 29 / 32 / 36
KV-27TW77 / 78
KV-27V10 / 15 / 55
KV-27XBR37 / 45
KV-32S10 / 12 / 15 / 16
KV-32TS36 / 46
KV-32TW67 / 68 / 77 / 78
KV-32V15 / 16
KV-32XBR37 / 45 / 85

Taken from:

http://www.iwaynet.net/~nesda/SonyCross.html

Thanks in advance for help.
Click to expand...
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top